en tout cas pour les 2 montage que ce soit no slip ou lock right
il faut enlever les differentiels des ponts les notices d'origines sont pas tres convainquante
il en faudrait une en francais que l'on puisse suivre sans probleme!!!!!
PROBLEME MONTAGE POWERTRAX
-
seb3177
- Trail rated
- Réactions :
- Messages : 9943
- Enregistré le : 04 janv. 2006 11:53
- Modèle : CJ 6
- Localisation : 83
C-Clip Axles
1. Remove the pinion shaft retaining bolt and the
pinion shaft.
2. Rotate the drivers until one of the right window holes
faces out. Push under the spring with a small sharp-pointed
pick and pry the end up. Push a small screwdriver or bent
piece of small wire (a paper clip works well) under the spring
and pop the bottom out. Push the pin out of the pin hole and
into the window hole. Repeat for the other three springs and
pins.
3. Move the right driver to the left, touching the left driver.
4. Move the right spacer to the left, into the center of the
left driver. (Use the U-shaped wire tool.)
5. Rotate the left tire and both drivers until the C-Clip
installation recess in the teeth of the right driver is pointing
down.
6. Tap the right tire inward to release the C-Clip so that
it falls down, through the recess.
7. Rotate the left tire to rotate both drivers and allow the
C-Clip to drop out of the case.
8. Pull the right tire out about one inch.
9. Push the spacers into the centers of the drivers.
10. Remove the driver and spacer opposite the ring
gear flange first and then remove the second driver.
11. Remove the left C-Clip.
12. Remove the couplers.
1. Remove the pinion shaft retaining bolt and the
pinion shaft.
2. Rotate the drivers until one of the right window holes
faces out. Push under the spring with a small sharp-pointed
pick and pry the end up. Push a small screwdriver or bent
piece of small wire (a paper clip works well) under the spring
and pop the bottom out. Push the pin out of the pin hole and
into the window hole. Repeat for the other three springs and
pins.
3. Move the right driver to the left, touching the left driver.
4. Move the right spacer to the left, into the center of the
left driver. (Use the U-shaped wire tool.)
5. Rotate the left tire and both drivers until the C-Clip
installation recess in the teeth of the right driver is pointing
down.
6. Tap the right tire inward to release the C-Clip so that
it falls down, through the recess.
7. Rotate the left tire to rotate both drivers and allow the
C-Clip to drop out of the case.
8. Pull the right tire out about one inch.
9. Push the spacers into the centers of the drivers.
10. Remove the driver and spacer opposite the ring
gear flange first and then remove the second driver.
11. Remove the left C-Clip.
12. Remove the couplers.
Eat, Sleep, Jeep
